#Symantec disk doctor software
This issue may be resolved in a future major revision of the software at a later time.
#Symantec disk doctor Patch
There are currently no plans to address this issue by way of a patch or hotfix in the current or previous versions of the software at the present time. Symantec is committed to product quality and satisfied customers. Symantec has acknowledged that the above-mentioned limitations is present in the current version(s) of the product(s) mentioned at the end of this article.
#Symantec disk doctor windows
Ghost does not support cloning a partition to a dynamic disk.Īfter cloning simple volume or mirrored volume to a basic disk, use the Windows Disk Management MMC utility to convert the destination partition to a simple or mirrored volume. Ghost supports cloning a partition from a dynamic disk to a basic disk for both simple volumes and mirrored volumes. Ghost supports creating a disk image of a dynamic disk only when using the -IA switch on the Ghost command line. To perform a disk-to-image cloning operation on a dynamic disk, run Ghost with the -IA switch on the Ghost command line, such as Note that the process is considerably slower than a partition-to-image process, and that the resulting image file will usually be much larger. Use a disk-to-image operation only as a last resort. In practice, this means the image can only be restored back to the same disk. To access the dynamic disk on the restored disk, the image must be restored to a drive with exactly the same geometry. If you want to restore a partition image to a dynamic disk, you must first convert the disk to a basic disk.īecause you can select all partitions on the source disk when performing a partition-to-image cloning operation, a disk-to-image clone is necessary only in unusual circumstances, and is only applicable for backup purposes. Note: Because Ghost cannot restore a partition image to a dynamic disk, you cannot use this process to convert a dynamic disk to a basic disk. After restoring the image to a basic disk, use the Windows Disk Management MMC utility to convert the partition to a simple or mirrored volume. Ghost will detect the simple and mirrored volumes and will save the contents of the volume as a non-dynamic partition. To clone a simple or mirrored volume, run Ghost normally. Ghost does not support restoring a partition to a dynamic disk. Ghost supports creating a partition image of a dynamic disk for both simple volumes and mirrored volumes and restoring that partition to a basic disk. To clone the entire disk, perform a partition-to-image operation and select all partitions on the source disk. The best way to use Ghost to clone a dynamic disk is to perform a single partition-to-image cloning operation and not a disk-to-image cloning operation. To clone a basic disk, run Ghost as usual. That is, a basic disk does not include simple, mirrored, spanned, striped, or RAID-5 volumes. "Basic disk" is the term used in Windows to indicate that the disk is not a dynamic disk. See the ghost release notes for more information on 3.2 RU4
This limitation has been addressed in 3.2 RU4 and later. On a drive with more than one partition the remaining partition images can't be created properly and won't be able to be restored properly. Also in GSS 3.0 and GSS 3.1 support for dynamic disk imaging is limited and is only able to be performed on the first partition.A PXE server could be used to deliver the automation environment or a automation boot disk can be used to connect to the Ghost console or use Ghost Multicast sever to perform imageing.
0 kommentar(er)
